DieselBike.net

And shes done.

https://www.youtube.com/watch?v=NHI-tVwG_xc

Long story short: I just got the driveshaft aligned then chopped and welded until everything followed suit.

I had to move the engine to the right to fulfill the critical dimension of matching up the drive shaft giubo to the drive shaft. This involved some drastic rigidity compromising frame cutting so I could retain sidecar capability. The Ural frame lower cradles are approx 1/4" thick round tube. I'...

A v50 gearbox? Funny story about this Ural drivetrain. When viewed from the rear, the 4 forward gears spin the driveshaft clockwise. So something in the kardan is different on Urals compared to Guzzis. But before this project started I made sure I wouldn't have 4 reverse gears!!!

Alright its been almost a year, but I've been busy with it. The Guzzi forum already snubbed me, so you guys are my only hope. Just Kidding. 6061 Aluminum Adapter built with 3/8" plate. Spacing between flanges is 1.1875 inches done with square bar. I beat in some roll pins to hold alignment, ins...

I plan on making my adapter plate from a thick piece of aluminum. 2 inches thick (.05 meters). and one square foot area (.09 meters^2). Im looking at about $250 USD. What's your idea for an adapter plate?

Thanks for the info. Im working with an Ural 650. But I seem to have the same need for low profile bolt heads. Mine is a 2001 Ural Deco which broke its crankshaft at 3000km!

Hi tetronator, and diesel heads. Im working on adapting an Ural flywheel was wondering if you could check out my idea. https://www.dieselbikeforum.com/view ... =31&t=3162

Thx,
-Matt

Whats up diesel heads? Im adapting an Ural flywheel on my own project and was wondering if I could have some input. Im pretty much trying to turn it into an automotive style flywheel by removing the boss, boring the taper and drilling a bolt circle. This is for a moto guzzi v50. I'm also designing t...

Hello diesel bike enthusiasts, I am a mechanical engineering student and longtime fan of this website. I'm working on a project which may interest some members on the forum. All comments and suggestions appreciated! While I am not building a diesel bike just yet, I was wondering if I could have some...