Just starting to get the project back on track.
Was putting a D830 in place of the D850, after the D850 had low compression on one cylinder.
it has a small set of differences, but the crank case size is the same.
Its bolted up and is driving the rear wheel but needs:
[*]Engine mounts on crank pulley side
[*]Alternator mount
[*]RPM counter sorting out
[*]There are no electrics for some reason?
[*] fuel tank needs cleaning out
lots of other bits!
Started straight up in -1deg weather 5 seconds of glow :
https://www.youtube.com/watch?v=rvGvcb8bqW0
New engine has done about 12 hours.
Reviving project after move
Moderators: Dan J, Diesel Dave, Crazymanneil, Stuart
-
alexanderfoti
- Site Admin
- Posts: 1290
- Joined: Fri Jul 15, 2011 4:22 pm
- Location: London
-
coachgeo
- I luv the smell of Diesel...
- Posts: 2002
- Joined: Sun Feb 22, 2009 6:00 am
- Location: USA Ohio, Above Cincinnati, Close to Dayton
Re: Reviving project after move
Glad to hear your back on project. Confused though. Video says engine is a D850.... thought you were replacing the 850 with 830?
-
alexanderfoti
- Site Admin
- Posts: 1290
- Joined: Fri Jul 15, 2011 4:22 pm
- Location: London
Re: Reviving project after move
I am , its a typocoachgeo wrote:Glad to hear your back on project. Confused though. Video says engine is a D850.... thought you were replacing the 850 with 830?
